Macsense Connectivity MPC-200 Manual de usuario descargar pdf (Pagina 29)

4. Turn off your computer and insert the Macsense Fast Ethernet CardBus Card into

the PC Card socket. Then attach the cable to the card.

5. Now turn your computer on and connect it to the network. If you cannot connect it to

the network, refer to the Appendix A and B.

The Install batch files

Before you can use your Macsense Fast Ethernet CardBus Card, you need to install

and modify some files in your computer system. You can make these changes by using

INSTALL batch files.

¥ INSTNWCL.BAT NetWare Driver Installation Batch File

¥ INSTWFW.BAT Windows For Workgroups Driver Installation Batch File

DOS ODI Client Driver Installation NetWare 3.x / 4.x Client

To install ODI driver, type INSTNWCL from a:\, and add two command lines to your

autoexec.bat file.

Steps as following:

1. Turn on the power and run your computer in DOS mode.

2. Insert Macsense Fast Ethernet CardBus Card Driver Diskette in drive A:

3. Type A: and press ENTER key

4. Type INSTNWCL and press ENTER key

5. Use MS-EDIT to add two command lines bellow to your AUTOEXEC.BAT file

PATH C:\NWCLIENT;%PATH%

C:\NWCLIENT\STARTCB.BAT

6. Reboot your computer

NOTE: The default directory for this install program to install files is named NWCLIENT.

The following ten files will be copied to LAN PC Card Netware driver directory:

LSL.COM supported by Novell

MCBODI.COM Novell DOS ODI Driver

IPXODI.COM supported by Novell

NETX.COM supported by Novell

NET.CFG optional, configuration file

Client Driver Installation

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 42 43

Sin comentarios

Macsense Connectivity MPC-200 Manual de usuario Pagina 29