Macsense Connectivity MIH-120 Manual de usuario descargar pdf (Pagina 10)

4.0 INSTALLING XROUTER AERO

Prior to connecting the XRouter Aero to LAN, please be certain that your DSL or

Cable service is active and operating correctly. If you are experiencing difficulties

with the DSL or Cable service, please contact the service provider before

continuing the installation process.

4.1 Connecting the XRouter Aero to Your DSL/Cable Modem

After verifying that your DSL or Cable service is functioning properly, connect the

DSL modem or Cable modem to the XRouter Aero by following the instructions

below:

1. Disconnect the Ethernet cable from the computer that is currently connected

to the DSL or Cable modem if you have not done so.

2. Plug the RJ-45 connector from this cable into the WAN (Wide Area Network)

port on the rear panel of the XRouter Aero (See

3. Figure 2). Verify WAN LED is green ensuring proper connection (See Figure

1).

4. Leave the other end of this Ethernet cable connected to the DSL modem or

Cable modem.

Mac

Figure 3

4.2 Connecting Computers to the XRouter Aero

When you finish connecting the XRouter Aero to your DSL or Cable modem, you

may now connect Macintosh or PC computers in your local area network to the

XRouter Aero.

Two methods can be implemented for the connection: (1) plugging computers

directly into the XRouter Aero, and (2) connecting the XRouter Aero to your LAN

hub. We suggest performing the initial installation process with just one computer

connected to the XRouter Aero and add the hub later.

Connect Computers Directly to the XRouter Aero:

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 55 56

Sin comentarios

Macsense Connectivity MIH-120 Manual de usuario Pagina 10